Most KABUKI products are presently packaged in sleeves. While all Kabuki launchers work well with less paper, or more if required, an average load for the 32" (81.3 cm) Launcher, the Auto-Launcher - 24 Volts and the small tube of the AC Auto-Launcher is 1 package. The 18" (45.7 cm) Launcher takes 1/2 a package. Larger tubes can hold considerably more.

To load, simply cut open one end of the sleeve and squeeze out the paper onto a table. With the aid of the packing rod (included) push small amounts of paper down the tube of the launcher. Pack the first 2" (5.1 cm) very tightly (use product or tissue paper) and the rest of your load snug. This will give you the best looking shots, maximum distance and the widest spread.

A sleeve contains approximately the following:

15' Streamers -- 100 to 120 streamers depending on cut (each approx. 1/4" (0.64 cm) wide).
Loading: Keep rows connected together (packaged in two rows) and load small handfuls as indicated above. These will get slightly mixed, not all lined up in the tube, which will give the best results.

30' Streamers -- 30 to 40 streamers depending on cut (each approx. 1/2" (1.27 cm) wide).
Loading: Load small handfuls as indicated above. Most streamers will tend to align themselves sideways -- it is OK if some streamers turn differently.

Bubble Confetti / Streamers -- Approx. 30 to 40 streamers depending on cut (each approx. 1/2" (1.27 cm) wide) and 17' (5.2 m) long. Bubbles are tissue confetti pieces that form a round, or bubble like effect, interlaced with streamers.
Loading: Load small handfuls as indicated above. Most streamers will tend to align themselves sideways -- it is OK if some streamers turn differently.

Slowfall Confetti -- Approx. 3500 sheets of confetti 1/2" (1.27 cm) by 2" (5.1 cm).
Loading: In the sleeve, the Slowfall Confetti is packaged in 1/2 inch stacks. You will get much more distance if you line up the stacks (2 or 3 depending) in your launcher. Push stacks down the barrel, one behind the other.